1.REMOVE ENGINE HANGERS
| *1 | No. 1 engine hanger |
| *2 | No. 2 engine hanger |
| *a | Bank 1 |
| *b | Bank 2 |
Remove the 4 bolts and 2 engine hangers.
17190
2.REMOVE INTAKE AIR SURGE TANK ASSEMBLY
17125
3.REMOVE NO. 1 SURGE TANK STAY
Remove the bolt and No. 1 surge tank stay.
22267A
4.REMOVE THROTTLE BODY BRACKET
Remove the bolt and throttle body bracket.
19500
5.REMOVE IGNITION COIL ASSEMBLY
12327A
6.REMOVE NO. 2 ENGINE MOUNTING STAY RH
Remove the bolt and No. 2 engine mounting stay RH.
17111
7.REMOVE INTAKE MANIFOLD
Uniformly loosen and remove the 6 bolts and 4 nuts.
Remove the intake manifold and 2 gaskets.
17104
8.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH
Uniformly loosen and remove the 6 nuts.
Remove the exhaust manifold sub-assembly RH and gasket.
12142
9.REMOVE NO. 2 ENGINE OIL LEVEL DIPSTICK GUIDE
Remove the oil level dipstick.
Remove the bolt and No. 2 engine oil level dipstick guide.
Remove the O-ring from the No. 2 engine oil level dipstick guide.
17119
10.REMOVE NO. 2 MANIFOLD STAY
17168
11.REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR
17105
12.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH
Uniformly loosen and remove the 6 nuts.
Remove the exhaust manifold assembly LH and gasket.
16620
13.REMOVE V-RIBBED BELT TENSIONER ASSEMBLY
Remove the 5 bolts and V-ribbed belt tensioner assembly.
11322F
14.REMOVE NO. 2 TIMING GEAR COVER
Remove the 2 bolts and No. 2 timing gear cover.
16173
15.REMOVE WATER PUMP PULLEY
Using SST, hold the water pump pulley.
Remove the 4 bolts and water pump pulley.
16604
16.REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY
Remove the bolt, No. 2 idler pulley cover plate, No. 2 idler pulley sub-assembly and idler pulley cover plate.
25860A
17.REMOVE NO. 1 VACUUM SWITCHING VALVE
Remove the bolt and No. 1 vacuum switching valve.
83530
18.REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY
Using a 24 mm deep socket wrench, remove the engine oil pressure switch assembly.
89615
19.REMOVE KNOCK CONTROL SENSOR
82219A
20.REMOVE KNOCK SENSOR WIRE
Disconnect the 3 clamps and remove the knock sensor wire from the engine assembly.
89422
21.REMOVE ENGINE COOLANT TEMPERATURE SENSOR
Using a 19 mm deep socket wrench, remove the engine coolant temperature sensor and gasket.