Home › Engine / Hybrid System › 2GR-FE INTAKE / EXHAUST › INTAKE MANIFOLD
RM2030EQ _51 Engine / Hybrid System _014638 2GR-FE INTAKE / EXHAUST _0074433 INTAKE MANIFOLD A

2GR-FE INTAKE / EXHAUST  INTAKE MANIFOLD  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2. DISCHARGE FUEL SYSTEM PRESSURE

Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 5.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

Hide 55702A 6.REMOVE FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)

Hide 55702A 7.REMOVE FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)

Hide 11209 8.REMOVE V-BANK COVER SUB-ASSEMBLY

Hide 9.REMOVE AIR CLEANER CAP SUB-ASSEMBLY

Hide 17190 10.REMOVE INTAKE AIR SURGE TANK ASSEMBLY

a.
A275076C01
0.082,0.047 0.255,0.206 0.173,0.159 10 *A 0.087,2.284 0.260,2.443 0.173,0.159 10 *B
*A for RHD
*B for LHD


Disconnect the ventilation hose.


b.

Disconnect the check valve to brake booster hose (for RHD).


c.

Disconnect the hose clamp and union to check valve hose (for LHD).


d.
A255505

Disconnect the connector and wire harness clamp.


e.

Disconnect the 2 water by-pass hoses and fuel vapor feed hose.


f.
A129467

Disconnect the connector from the intake air control valve assembly.


g.
A255338

Remove the bolt and vacuum hose clamp.


h.
A255339

Remove the bolt and separate the throttle body bracket from the intake air surge tank assembly.


i.
A255340

Remove the bolt and separate the No. 1 surge tank stay from the intake air surge tank assembly.


j.
A255341

Remove the 2 nuts from the intake air surge tank assembly.


k.

Using a 5 mm socket hexagon wrench, remove the 4 bolts.


l.
A255342

Remove the intake air surge tank assembly and 3 gaskets.


Hide 12327A 11.REMOVE NO. 2 ENGINE MOUNTING STAY RH (for Engine Mounting stay Side)

Hide 12327A 12.REMOVE NO. 2 ENGINE MOUNTING STAY RH (for Intake Manifold Side)

Hide 23901 13.DISCONNECT FUEL TUBE SUB-ASSEMBLY

Hide 23807 14.REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY

Hide 17111 15.REMOVE INTAKE MANIFOLD

a.
A192818

Remove the 6 bolts, 4 nuts and intake manifold.


b.
A255344

Remove the 2 gaskets.