Home › Engine / Hybrid System › 2GR-FE INTAKE / EXHAUST › EXHAUST MANIFOLD
RM2030EQ _51 Engine / Hybrid System _014638 2GR-FE INTAKE / EXHAUST _0074438 EXHAUST MANIFOLD A

2GR-FE INTAKE / EXHAUST  EXHAUST MANIFOLD  REMOVAL  


PROCEDURE

Hide 53851Z 1.REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

Hide 51441C 2.REMOVE ENGINE UNDER COVER RH

Hide 16470 3.REMOVE RADIATOR RESERVE TANK ASSEMBLY

Hide 17584B 4.REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET (for Front Side)

Hide 17410 5.REMOVE FRONT EXHAUST PIPE ASSEMBLY

a.
A255349

Disconnect the 2 wire harnesses from the clamp.


b.

Disconnect the 2 heated oxygen sensor connectors.


c.
A255350

Remove the 2 bolts and No. 1 exhaust pipe support bracket (for Rear Side).


d.
A255351

Remove the 4 bolts, 4 nuts and front exhaust pipe assembly.


e.

Remove the 3 gaskets from the front exhaust pipe assembly.


Hide 89467B 6.REMOVE AIR FUEL RATIO SENSOR (for Bank 1)

Hide 17104 7.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH

a.
A255521

Using a 12 mm deep socket wrench, remove the 6 nuts and exhaust manifold sub-assembly RH.


b.
A255352

Remove the gasket from the cylinder head sub-assembly.


Hide 89467B 8.REMOVE AIR FUEL RATIO SENSOR (for Bank 2)

Hide 12142 9.REMOVE NO. 2 ENGINE OIL LEVEL DIPSTICK GUIDE

Hide 17168 10.REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR

a.
A197636

Remove the 3 bolts and No. 2 exhaust manifold heat insulator.


Hide 17119 11.REMOVE NO. 2 MANIFOLD STAY

a.
A140783

Remove the bolt, nut and No. 2 manifold stay.


Hide 17105 12.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH

a.
A197637

Using a 12 mm deep socket wrench, remove the 6 nuts and exhaust manifold sub-assembly LH.


b.
A255353

Remove the gasket from the cylinder head sub-assembly.