Home › Drivetrain › U660E AUTOMATIC TRANSMISSION / TRANSAXLE › TCM
RM2030EQ _52 Drivetrain _014643 U660E AUTOMATIC TRANSMISSION / TRANSAXLE _0074474 TCM A

U660E AUTOMATIC TRANSMISSION / TRANSAXLE  TCM  INSTALLATION  


PROCEDURE

Hide 1.INSTALL TCM

a.
C241670N02
2.094,0.188 2.219,0.344 0.125,0.156 10 false 1 1.469,0.188 1.688,0.365 0.219,0.177 10 true 2

Install the TCM to the automatic transaxle assembly with the 2 bolts in the order shown in the illustration.

Torque:
11 N*m (115 kgf*cm, 8 ft.*lbf)


b.
C239667

Connect the connector to the TCM.


c.

Turn the lock lever and secure the connector with the lock lever.


Hide 17751 2.INSTALL INLET NO. 1 AIR CLEANER

Hide 4.INSTALL AIR CLEANER CASE SUB-ASSEMBLY

Hide 17801 5.INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 6.INSTALL AIR CLEANER CAP SUB-ASSEMBLY

Hide 17752 7.INSTALL INLET NO. 2 AIR CLEANER

Hide 53295E 8.INSTALL COOL AIR INTAKE DUCT SEAL

Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 10.CHECK AUTOMATIC TRANSAXLE SYSTEM

NOTICE:

If automatic transaxle parts have been replaced, refer to Parts Replacement Compensation Table to determine if any additional operations are necessary.

Click hereDrivetrain>U660E AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSAXLE SYSTEM>PRECAUTION