Home › Drivetrain › U660E AUTOMATIC TRANSMISSION / TRANSAXLE › SHIFT PADDLE SWITCH
RM2030EQ _52 Drivetrain _014643 U660E AUTOMATIC TRANSMISSION / TRANSAXLE _0074478 SHIFT PADDLE SWITCH A

U660E AUTOMATIC TRANSMISSION / TRANSAXLE  SHIFT PADDLE SWITCH  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

Do not replace the spiral cable with the battery connected and the ignition switch ON.

·

Do not rotate the spiral cable without the steering wheel with the battery connected and the ignition switch ON.

·

Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.

·

Do not remove the steering sensor from the spiral cable.



PROCEDURE

Hide 84523 1.CONNECT NO. 1 SWITCH WIRE

a.

Connect the 2 No. 1 switch wire connectors to the 2 shift paddle switches (transmission shift switch assembly).


b.
C224820C11
1.489,0.279 1.683,0.451 0.195,0.172 10 *1 1.866,0.279 2.06,0.451 0.195,0.172 10 *1 0.76,1.661 0.954,1.833 0.195,0.172 10 *a 2.603,1.678 2.798,1.85 0.195,0.172 10 *a 0.619,2.828 0.814,3.0 0.195,0.172 10 *b 2.888,2.518 3.083,2.691 0.195,0.172 10 *b 2.056,0.358 2.172,0.358 2.172,0.358 2.225,0.915 false 1.475,0.376 1.383,0.376 1.383,0.376 1.305,0.915 false
*1 Clamp
*a 0 to 40°
*b 1 to 3 mm


Install 2 new clamps as shown in the illustration.


c.

Engage the 5 guides to install the No. 1 switch wire.


Hide 84610F 2.INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)

a.

Engage the 4 pins and install the 2 shift paddle switches (transmission shift switch assembly) with the 2 screws.

Torque:
1.3 N*m (13 kgf*cm, 12 in.*lbf)


Hide 84250A 3.INSTALL STEERING PAD SWITCH ASSEMBLY

Hide 4. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

Hide 84306 5.INSPECT AND ADJUST SPIRAL CABLE SUB-ASSEMBLY

Hide 45100 6.INSTALL STEERING WHEEL ASSEMBLY

Hide 7. CHECK STEERING WHEEL CENTER POINT

Hide 45130 8.INSTALL HORN BUTTON ASSEMBLY