Home › Steering › STEERING COLUMN › STEERING WHEEL(for 3 Spoke) › 2012.02–2015.04
RM2030EQ _55 Steering _014656 STEERING COLUMN _0074535 STEERING WHEEL(for 3 Spoke) A

STEERING COLUMN  STEERING WHEEL(for 3 Spoke)  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

Do not replace the spiral cable with sensor sub-assembly with the battery connected and the ignition switch to ON.

·

Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the battery connected and the ignition switch to ON.

·

Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.



PROCEDURE

Hide 45713A 1.INSTALL STEERING SHAKE DAMPER

a.

Install the steering shake damper to the steering wheel sub-assembly with the 2 screws.

Torque:
2.4 N*m (24 kgf*cm, 21 in.*lbf)


Hide 84633 2.INSTALL CRUISE CONTROL SWITCH WIRE

a.

Install the cruise control switch wire.


Hide 84632 3.INSTALL CRUISE CONTROL MAIN SWITCH

Hide 84610F 5.INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)

Hide 84250A 6.INSTALL STEERING PAD SWITCH ASSEMBLY

Hide 7.ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

Hide 8.INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

Hide 45100 9.INSTALL STEERING WHEEL ASSEMBLY

a.
C239680C04
0.238,0.368 0.399,0.519 0.161,0.152 10 *a 1.724,0.448 0.427,0.448 false 1.728,0.652 0.65,0.652 0.65,0.652 0.65,0.448 false
*a Matchmark


Install the steering wheel assembly aligning the matchmarks on the steering wheel assembly and steering main shaft.


b.

Install the steering wheel assembly set nut.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)


c.

Connect the connectors to the spiral cable sub-assembly and steering wheel assembly.


Hide 10.CHECK STEERING WHEEL CENTER POINT

Hide 45130 11.INSTALL HORN BUTTON ASSEMBLY