Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB
RM2030EQ _52 Drivetrain _014645 AXLE AND DIFFERENTIAL _0074486 REAR AXLE HUB A

AXLE AND DIFFERENTIAL  REAR AXLE HUB  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 42450B 1.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

a.

Install the rear axle hub and bearing assembly and parking brake assembly to the rear axle carrier sub-assembly with the 4 bolts.

Torque:
80 N*m (816 kgf*cm, 59 ft.*lbf)


Hide 2.INSPECT REAR AXLE HUB BEARING LOOSENESS

Hide 89516D 4.CONNECT SKID CONTROL SENSOR WIRE

Hide 42431 5.INSTALL REAR DISC

Hide 42491 6.INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG

Hide 7.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

Hide 8.ADJUST PARKING BRAKE

Hide 9.INSTALL REAR WHEEL

Torque:
103 N*m (1049 kgf*cm, 76 ft.*lbf)