Home › Suspension › FRONT SUSPENSION › FRONT LOWER SUSPENSION ARM
RM2030EQ _53 Suspension _014647 FRONT SUSPENSION _0074494 FRONT LOWER SUSPENSION ARM A

FRONT SUSPENSION  FRONT LOWER SUSPENSION ARM  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 48069 1.INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY

a.

Install the front lower arm bushing stopper to the front lower No. 1 suspension arm sub-assembly.


b.
C167143E01
0.656,0.357 0.795,0.515 0.139,0.158 10 1 1.147,0.24 1.286,0.398 0.139,0.158 10 2 2.467,0.926 2.613,1.077 0.146,0.150 10 3

Install the front lower No. 1 suspension arm sub-assembly to the front frame assembly with the 3 bolts and nut in the order shown in the illustration.

Torque:
Bolt 1, 2 : 200 N*m (2039 kgf*cm, 148 ft.*lbf)
Bolt 3 : 135 N*m (1377 kgf*cm, 100 ft.*lbf)

NOTICE:

While keeping the nut from rotating, tighten the bolt.



Hide 12372A 2.INSTALL ENGINE MOUNTING INSULATOR (When Not Using the Engine Support Bridge)

Hide 51100G 3.INSTALL FRONT FRAME ASSEMBLY