Use the same procedure for the RH side and LH side.
The procedure listed is for the LH side.
51100G
1.REMOVE FRONT FRAME ASSEMBLY
When Not Using the Engine Support Bridge: Click hereEngine / Hybrid System>2GR-FE ENGINE MECHANICAL>ENGINE ASSEMBLY>REMOVAL
When Using the Engine Support Bridge for LHD: Click hereSuspension>FRONT SUSPENSION>FRONT SUSPENSION MEMBER(When Using the Engine Support Bridge for LHD)>REMOVAL
12372A
2.REMOVE ENGINE MOUNTING INSULATOR (When Not Using the Engine Support Bridge)
48069
3.REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY
Remove the 3 bolts, nut and front lower No. 1 suspension arm sub-assembly from the front frame assembly.
When removing the bolt, keep the nut from rotating.
Remove the front lower arm bushing stopper from the front lower No. 1 suspension arm sub-assembly.