Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION RECEIVER › 2012.02–2015.04
RM2030EQ _56 Audio / Visual / Telematics _014659 NAVIGATION / MULTI INFO DISPLAY _0074554 NAVIGATION RECEIVER A

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION RECEIVER  INSTALLATION  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

When installing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.


Hide 2.INSTALL NAVIGATION ECU SUB-ASSEMBLY

Hide 55900 4.INSTALL AIR CONDITIONING CONTROL ASSEMBLY

Hide 86211J 5.INSTALL NO. 1 RADIO RECEIVER BRACKET

a.

Install the No. 1 radio receiver bracket with the 5 screws.


Hide 86212C 6.INSTALL NO. 2 RADIO RECEIVER BRACKET

a.

Install the No. 2 radio receiver bracket with the 5 screws.


Hide 7.INSTALL NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY

a.

Connect each connector.


b.

Engage the 6 clips to the vehicle body to temporarily install the navigation receiver assembly with air conditioning control assembly.


c.

Install the navigation receiver assembly with air conditioning control assembly with the 4 bolts.


Hide 58831A 8.INSTALL FRONT CONSOLE UPPER PANEL GARNISH

Hide 55660 9.INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55405B 10.INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION