Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
69284D
3.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG
4.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
74260
5.REMOVE REAR ARMREST ASSEMBLY
67604
6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
68174A
7.REMOVE REAR DOOR INNER GLASS WEATHERSTRIP
67842E
8.REMOVE REAR DOOR SERVICE HOLE COVER
67872
9.DISCONNECT REAR DOOR WEATHERSTRIP
68152C
10.REMOVE REAR DOOR GLASS RUN
67408F
11.REMOVE REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY
68124B
12.REMOVE REAR DOOR QUARTER WINDOW GLASS
Remove the rear door quarter window glass as shown in the illustration.
68104
13.REMOVE REAR DOOR GLASS SUB-ASSEMBLY
69060A
14.REMOVE REAR DOOR LOCK WITH MOTOR ASSEMBLY
| *1 | Release Plate |
Using a T30 "TORX" socket wrench, remove the 3 screws.
Move the rear door lock with motor assembly downward and pull the release plate out of the rear door outside handle frame.
When reusing the rear door lock with motor assembly:
Remove the door lock wiring harness seal from the rear door lock with motor assembly.
69740D
15.REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY
69780B
16.REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY