83100
1.INSTALL COMBINATION METER ASSEMBLY
Connect the 2 connectors.
Engage the wire harness clamp.
Install the combination meter assembly with the 4 screws.
55410C
2.INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
55650
3.INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY
55431B
4.INSTALL UPPER INSTRUMENT PANEL FINISH PANEL (for RHD)
55318C
5.INSTALL INSTRUMENT SIDE PANEL
62312B
6.CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
for LHD : Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION
for RHD : Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION
7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION