73900
1.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
| *1 | Airbag Connector |
| *2 | Airbag Connector Lock |
Connect the airbag connector to the lower No. 1 instrument panel airbag assembly.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Push in the lock to install the airbag connector.
Temporarily install the lower No. 1 instrument panel airbag assembly with the 2 hooks.
Engage the 2 claws to install the DLC3.
Install the 4 bolts.
Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.
55432D
2.INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
53601
3.CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Perform the same procedure as the driver side of LHD vehicles (See page Vehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>INSTALLATION).
55317A
4.INSTALL INSTRUMENT SIDE PANEL RH
Perform the same procedure as the driver side of LHD vehicles (See page Vehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>INSTALLATION).
62311B
5.CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH
62111A
6.INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH
Perform the same procedure as the driver side of LHD vehicles (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION).
67913
7.INSTALL FRONT DOOR SCUFF PLATE RH
Perform the same procedure as the driver side of LHD vehicles (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION).
8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
9. PERFORM DIAGNOSTIC SYSTEM CHECK
10.INSPECT SRS WARNING LIGHT