Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CENTER AIRBAG SENSOR ASSEMBLY
RM2030EQ _58 Vehicle Interior _014669 SUPPLEMENTAL RESTRAINT SYSTEMS _0074627 CENTER AIRBAG SENSOR ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  CENTER AIRBAG SENSOR ASSEMBLY  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 67914 4.REMOVE FRONT DOOR SCUFF PLATE LH

Hide 62112A 5.REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH

Hide 62312B 6.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH

Hide 55318C 7.REMOVE INSTRUMENT SIDE PANEL LH

Hide 53601 8.DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

Hide 55432D 9.REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

Hide 67913 10.REMOVE FRONT DOOR SCUFF PLATE RH

HINT:

Use the same procedure for the RH side and LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL).


Hide 62111A 11.REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:

Use the same procedure for the RH side and LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL).


Hide 62311B 12.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH

HINT:

Use the same procedure for the RH side and LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL).


Hide 55317A 13.REMOVE INSTRUMENT SIDE PANEL RH

Hide 55607 14.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55303B 15.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 58831A 16.REMOVE FRONT CONSOLE UPPER PANEL GARNISH

Hide 74110E 17.REMOVE FRONT ASH RECEPTACLE ASSEMBLY

Hide 58817A 18.REMOVE FRONT NO. 2 CONSOLE BOX INSERT

Hide 58544A 20.REMOVE FLOOR CARPET BRACKET LH

Hide 58543B 21.REMOVE FLOOR CARPET BRACKET RH

Hide 58861B 22.REMOVE NO. 1 CONSOLE BOX DUCT

Hide 89170 23.REMOVE AIRBAG SENSOR ASSEMBLY

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.

Turn back the carpet.


d.
B278814

Disconnect the connectors from the airbag sensor assembly as shown in the illustration.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.



e.

Remove the 3 bolts and airbag sensor assembly.