1.REMOVE FRONT BUMPER ASSEMBLY
2.REMOVE FRONT WHEEL LH (for LHD)
53876A
3.REMOVE FRONT FENDER LINER LH (for LHD)
Use the same procedure for the RH side and LH side.
Click hereVehicle Exterior>WIPER / WASHER>WASHER MOTOR>REMOVAL
4.REMOVE FRONT WHEEL RH (for RHD)
53851Z
5.REMOVE FRONT WHEEL OPENING EXTENSION PAD RH (for RHD)
53875A
6.REMOVE FRONT FENDER LINER RH (for RHD)
67914
7.REMOVE FRONT DOOR SCUFF PLATE LH (for LHD)
62112A
8.REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH (for LHD)
67913
9.REMOVE FRONT DOOR SCUFF PLATE RH (for RHD)
Use the same procedure for the RH side and LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
62111A
10.REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH (for RHD)
Use the same procedure for the RH side and LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
53601
11.DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
53601
12.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Disconnect the hood lock control cable assembly and remove the hood lock control lever sub-assembly.
53510
13.REMOVE HOOD LOCK ASSEMBLY (for LHD)
| *1 | Protective Tape |
Using a screwdriver, remove the hood lock nut cap.
Tape the screwdriver tip before use.
| *1 | Hood Lock Bolt |
Remove the 2 bolts and hood lock bolt.
Disconnect the hood lock control cable assembly and remove the hood lock assembly.
53510
14.REMOVE HOOD LOCK ASSEMBLY (for RHD)
| *1 | Protective Tape |
Using a screwdriver, remove the hood lock nut cap.
Tape the screwdriver tip before use.
Disconnect the connector.
| *1 | Hood Lock Bolt |
Remove the 2 bolts and hood lock bolt.
Disconnect the hood lock control cable assembly and remove the hood lock assembly.
53630
15.REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)
Using a screwdriver, disengage the 5 clamps and hood cable grommet as shown in the illustration.
| *1 | Hood Lock Control Cable | *2 | Hood Cable Grommet |
| *3 | Washer Hose | *4 | Hood Lock Control Cable Clamp |
Tape the screwdriver tip before use.
Pull the hood lock control cable assembly from the engine compartment and remove it.
53630
16.REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)
Using a screwdriver, disengage the 4 clamps and hood cable grommet as shown in the illustration.
| *1 | Hood Lock Control Cable | *2 | Hood Cable Grommet |
| *3 | Washer Hose | *4 | Hood Lock Control Cable Clamp |
Tape the screwdriver tip before use.
Pull the hood lock control cable assembly from the engine compartment and remove it.