Use the following procedure to troubleshoot the engine immobiliser system.
*: Use the intelligent tester.
| Proceed to |
|---|
| NEXT |
NEXT
In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.
The following 5 items are important points in the problem analysis:
| What | Vehicle model, system name |
| When | Date, time, occurrence frequency |
| Where | Road conditions |
| Under what conditions? | Driving conditions, weather conditions |
| How did it happen? | Problem symptoms |
| Proceed to |
|---|
| NEXT |
NEXT
Measure the battery voltage.
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs and note any codes that are output.
Clear the DTCs.
Recheck for DTCs. Based on the DTCs output above, try to duplicate the engine immobiliser system DTC by simulating the symptoms indicated by the DTCs.
| Result | Proceed to |
|---|---|
| No DTCs are output | A |
| Engine immobiliser system DTC is output | B |
A
B
Clear the DTCs.
Recheck for DTCs.
The DTCs for the engine immobiliser system are specified below. If other DTCs are output, check the DTC chart for the SFI system.
| Result | Proceed to |
|---|---|
| No DTCs are output | A |
| Engine immobiliser system DTC is output (DTC B2799, B279A or B279C) | B |
| SFI system DTC is output (except DTC B2799, B279A and B279C) | C |
A
B
C
Click hereEngine / Hybrid System>2GR-FE ENGINE CONTROL>SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Immobiliser / Data List.
Read the Data List according to the display on the intelligent tester.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Key SW | Unlock warning switch signal | ON or OFF | ON: Key in ignition key cylinder
OFF: No key in ignition key cylinder |
- |
| Tester Display |
|---|
| Key SW |
On the intelligent tester screen, the item changes between ON and OFF according to the chart above.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Refer to Problem Symptoms Table.
| Result | Proceed to |
|---|---|
| Fault is not listed in Problem Symptoms Table | A |
| Fault is listed in Problem Symptoms Table | B |
A
B
Data List / Active Test
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT