Home › Vehicle Exterior › LIGHTING (EXT) › AFS (ADAPTIVE FRONT-LIGHTING SYSTEM) › 2012.02–2015.04
RM2030EQ _59 Vehicle Exterior _014680 LIGHTING (EXT) _0074739 AFS (ADAPTIVE FRONT-LIGHTING SYSTEM) C

LIGHTING (EXT)  AFS (ADAPTIVE FRONT-LIGHTING SYSTEM)  B2416  Height Control Sensor Malfunction  


DESCRIPTION

The DTC is stored when the AFS ECU (headlight swivel ECU assembly) detects malfunctions in the rear height control sensor sub-assembly power source or rear height control sensor sub-assembly.

DTC No. Detection Item DTC Detection Condition Trouble Area
B2416 Height Control Sensor Malfunction
·

Malfunction in rear height control sensor sub-assembly

·

Open or short in rear height control sensor sub-assembly power source circuit


·

Rear height control sensor sub-assembly

·

Harness or connector

·

AFS ECU (headlight swivel ECU assembly)



WIRING DIAGRAM

E144299E43
0.673,2.659 0.979,2.814 0.305,0.155 10 O17 0.673,2.81 3.35,3.006 2.676,0.196 10 Rear Height Control Sensor Sub-assembly 4.976,2.678 5.311,2.833 0.336,0.155 10 A35 4.976,2.842 6.757,3.166 1.782,0.325 10 AFS ECU (Headlight Swivel ECU Assembly) 1.674,0.849 1.997,1.006 0.323,0.156 10 SHB 1.674,2.185 1.997,2.341 0.323,0.156 10 SHG 1.581,1.503 1.996,1.659 0.416,0.156 10 SHRR 5.041,0.849 5.438,1.006 0.397,0.156 10 SBR 5.041,2.185 5.364,2.341 0.323,0.156 10 SGR 5.041,1.503 5.457,1.659 0.416,0.156 10 SHRL 2.076,0.733 2.202,0.89 0.126,0.157 10 3 4.767,0.733 4.955,0.89 0.189,0.157 10 18 4.767,1.414 4.955,1.571 0.189,0.157 10 19 4.767,2.08 4.955,2.237 0.189,0.157 10 21 2.076,1.407 2.202,1.564 0.126,0.157 10 2 2.076,2.08 2.202,2.237 0.126,0.157 10 1

CAUTION / NOTICE / HINT

NOTICE:

If either of the following is performed, initialization of the AFS ECU (headlight swivel ECU assembly) is necessary (See page Vehicle Exterior>LIGHTING (EXT)>AFS (ADAPTIVE FRONT-LIGHTING SYSTEM)>INITIALIZATION).

·

Replacement of the AFS ECU (headlight swivel ECU assembly).

·

Replacement or removal/installation of the rear height control sensor sub-assembly or work that changes the vehicle height such as replacement of suspension components.



PROCEDURE

1.CHECK FOR DTC
a.

Clear the DTCs.

Click hereVehicle Exterior>LIGHTING (EXT)>AFS (ADAPTIVE FRONT-LIGHTING SYSTEM)>DTC CHECK / CLEAR

Body Electrical > AFS > Clear DTCs
50002 165

b.

Check for DTCs.

Click hereVehicle Exterior>LIGHTING (EXT)>AFS (ADAPTIVE FRONT-LIGHTING SYSTEM)>DTC CHECK / CLEAR

Body Electrical > AFS > Trouble Codes
50001 165
OK:

DTC B2416 is not output.



Result:
Proceed to
OK
NG



OK

NG

2.READ VALUE USING INTELLIGENT TESTER
2.READ VALUE USING INTELLIGENT TESTER
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / AFS / Data List.


e.

Read the display on the intelligent tester.

Body Electrical > AFS > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Height Sens Pw Supply Val Height control sensor power supply value 0.00 to 6.25 V Approx. 5.0 V -
Body Electrical > AFS > Data List
Tester Display
Height Sens Pw Supply Val
50003 165 8
OK:

Normal condition listed above is displayed.



Result:
Proceed to
OK
NG



OK

REPLACE AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY)

NG

3.INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY
3.INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY
a.

Remove the rear height control sensor sub-assembly.

Click hereVehicle Exterior>LIGHTING (EXT)>HEIGHT CONTROL SENSOR>REMOVAL


b.

Inspect the rear height control sensor sub-assembly.

Click hereVehicle Exterior>LIGHTING (EXT)>HEIGHT CONTROL SENSOR>INSPECTION


Result:
Proceed to
OK
NG



OK

4.CHECK HARNESS AND CONNECTOR (AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY) - REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY)

NG

REPLACE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY

4.CHECK HARNESS AND CONNECTOR (AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY) - REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY)
a.

Disconnect the A35 AFS ECU (headlight swivel ECU assembly) connector.


b.

Disconnect the O17 rear height control sensor sub-assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A35-18 (SBR) - O17-3 (SHB) Always Below 1 Ω
A35-19 (SHRL) - O17-2 (SHRR) Always Below 1 Ω
A35-21 (SGR) - O17-1 (SHG) Always Below 1 Ω
A35-18 (SBR) - Body ground Always 10 kΩ or higher
A35-19 (SHRL) - Body ground Always 10 kΩ or higher
A35-21 (SGR) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

REPLACE AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR