Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM
RM2030EQ _58 Vehicle Interior _014672 HEATING / AIR CONDITIONING _0074651 AIR CONDITIONING SYSTEM C

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  B1451/51  Compressor Solenoid Circuit  


DESCRIPTION

In this circuit, the cooler compressor assembly (compressor solenoid) receives a refrigerant compression demand signal from the air conditioning amplifier assembly.

Based on this signal, the cooler compressor assembly (compressor solenoid) changes the amount of compressor output.


DTC No. Detection Item DTC Detection Condition Trouble Area Memory
B1451/51 Compressor Solenoid Circuit Open or short in compressor solenoid circuit
·

Cooler compressor assembly (compressor solenoid)

·

Harness or connector between air conditioning amplifier assembly and cooler compressor assembly (compressor solenoid)

·

Air conditioning amplifier assembly


-

WIRING DIAGRAM

E229254
5.01,0.792 5.104,0.969 0.094,0.177 10 false 2 3.833,0.792 3.927,0.969 0.094,0.177 10 false 2 2.448,0.792 2.542,0.969 0.094,0.177 10 false 1 5.229,0.885 5.688,1.063 0.458,0.177 10 false SOL+ 3.385,0.792 3.76,0.969 0.375,0.177 10 false SOL+ 2.667,0.792 3.01,0.969 0.344,0.177 10 false SOL- 4.823,3.5 5.167,3.677 0.344,0.177 10 false I77 4.823,3.667 6.469,4 1.646,0.333 10 false Air Conditioning Amplifier Assembly 2.25,1.49 4.083,1.917 1.833,0.427 10 false Cooler Compressor Assembly (Compressor Solenoid) 2.25,1.333 2.74,1.615 0.49,0.281 10 false E74

PROCEDURE

1.INSPECT COOLER COMPRESSOR ASSEMBLY (COMPRESSOR SOLENOID)
a.
E229635
2.49,1.677 2.927,1.969 0.438,0.292 1.5,2 1.25,2.417 false 1.969,1.979 2.219,2.396 false 0.167,0.219 0.625,0.781 0.458,0.563 10 false *a 2.604,1.74 3.083,2.021 0.479,0.281 10 false E74 2.115,2.438 2.708,2.729 0.594,0.292 10 false SOL- 1.021,2.448 1.625,2.74 0.604,0.292 10 false SOL+
*a Component without harness connected
(Cooler Compressor Assembly (Compressor Solenoid))


Disconnect the E74 cooler compressor assembly (compressor solenoid) connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
E74-2 (SOL+) - E74-1 (SOL-) 20°C (68°F) 10 to 11 Ω



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (COOLER COMPRESSOR ASSEMBLY (COMPRESSOR SOLENOID) - BODY GROUND)

NG

REPLACE COOLER COMPRESSOR ASSEMBLY

2.CHECK HARNESS AND CONNECTOR (COOLER COMPRESSOR ASSEMBLY (COMPRESSOR SOLENOID) - BODY GROUND)
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
E74-1 (SOL-) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (COOLER COMPRESSOR ASSEMBLY (COMPRESSOR SOLENOID) - AIR CONDITIONING AMPLIFIER ASSEMBLY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK HARNESS AND CONNECTOR (COOLER COMPRESSOR ASSEMBLY (COMPRESSOR SOLENOID) - AIR CONDITIONING AMPLIFIER ASSEMBLY)
a.

Disconnect the I77 air conditioning amplifier assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I77-2 (SOL+) - E74-2 (SOL+) Always Below 1 Ω
I77-2 (SOL+) - Body ground Always 10 kΩ or higher


Result:
Result Proceed to
NG A
OK (When troubleshooting according to Problem Symptoms Table) B
OK (When troubleshooting according to the DTC) C




A

REPAIR OR REPLACE HARNESS OR CONNECTOR

B

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

C

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY