Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM › 2012.02–2015.04
RM2030EQ _56 Audio / Visual / Telematics _014660 PARK ASSIST / MONITORING _0074557 PARKING ASSIST MONITOR SYSTEM J

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM  Image from Camera for Parking Assist Monitor is Abnormal  


DESCRIPTION

The video signal from the rear television camera assembly is transmitted to the navigation ECU sub-assembly.

WIRING DIAGRAM

E226207E27
0.135,2.76 2.208,3.115 2.073,0.354 10 false Navigation ECU Sub-assembly 5.396,0.656 5.573,0.823 0.177,0.167 10 false 3 5.396,1.188 5.573,1.354 0.177,0.167 10 false 2 5.396,0.125 5.573,0.292 0.177,0.167 10 false 6 5.396,1.719 5.573,1.885 0.177,0.167 10 false 5 5.615,0.729 6.031,0.896 0.417,0.167 10 false CV+ 5.615,1.271 6.031,1.438 0.417,0.167 10 false CV- 5.615,0.198 6.031,0.365 0.417,0.167 10 false CB+ 5.615,1.813 6.083,1.979 0.469,0.167 10 false CGND 2.021,1.083 2.219,1.25 0.198,0.167 10 false 16 2.021,1.615 2.219,1.781 0.198,0.167 10 false 15 2.063,2.146 2.26,2.313 0.198,0.167 10 false 7 1.594,0.74 2.01,0.906 0.417,0.167 10 false V+ 1.604,1.271 2.021,1.438 0.417,0.167 10 false V- 1.521,0.198 1.938,0.365 0.417,0.167 10 false CA+ 1.385,1.813 1.854,1.979 0.469,0.167 10 false CGND 1.385,2.344 1.854,2.51 0.469,0.167 10 false GND1 5.469,2.938 6.906,3.354 1.438,0.417 10 false Rear Television Camera Assembly 3.438,3.125 4.344,3.333 0.906,0.208 10 false *1: Shielded 4.521,1.938 4.771,2.135 0.25,0.198 10 false *1 3.833,1.938 4.083,2.135 0.25,0.198 10 false *1 3.135,1.948 3.385,2.146 0.25,0.198 10 false *1 2.063,0.552 2.24,0.719 0.177,0.167 10 false 8 2.063,0.031 2.24,0.198 0.177,0.167 10 false 7 5.469,2.76 5.667,2.927 0.198,0.167 10 false T6 2,0.74 2.26,0.906 0.26,0.167 10 false I66 2.01,1.271 2.271,1.438 0.26,0.167 10 false I66 2.01,0.208 2.271,0.375 0.26,0.167 10 false I66 2.01,1.802 2.24,1.969 0.229,0.167 10 false I66 2.01,2.333 2.26,2.5 0.25,0.167 10 false I64

CAUTION / NOTICE / HINT

NOTICE:
·

When "System initializing" is displayed on the navigation ECU sub-assembly after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>INITIALIZATION

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>CALIBRATION



HINT:

Images may be unclear even in normal conditions if:

·

Electrical devices are used in the cabin (noise may occur in the image).

·

Accessories that generate radio waves have been installed (noise may occur in the image).

·

The camera screen is frosted over (the image immediately after turning the engine switch to on (IG) may be blurred or darker than normal).

·

The camera lens is dirty with snow, mud, etc.

·

A strong beam of light, such as a sunbeam or headlight, hits the camera.

·

It is too dark around the camera (at night etc.).

·

The ambient temperature around the camera is either too high or too low.

·

The vehicle is tilted at a steep angle.

·

The rear television camera assembly lens is scratched.

·

The rear television camera assembly lens has drops of water on it or the humidity is high.

·

When the camera is used under fluorescent lights, sodium lights, or mercury lights etc., the lights and the illuminated area may appear to flicker.



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION ECU SUB-ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY)

OK

2.INSPECT NAVIGATION ECU SUB-ASSEMBLY (V-, CGND, CA+)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.INSPECT NAVIGATION ECU SUB-ASSEMBLY (V-, CGND, CA+)

OK

3.INSPECT NAVIGATION ECU SUB-ASSEMBLY (V+, GND1)

NG

3.INSPECT NAVIGATION ECU SUB-ASSEMBLY (V+, GND1)

OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPLACE REAR TELEVISION CAMERA ASSEMBLY