This circuit is from the parking brake switch assembly to the navigation ECU sub-assembly.
Check that the brake warning light comes on when the parking brake is applied and goes off when it is released.
The brake warning light operates as specified above.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the navigation ECU sub-assembly connector.
Disconnect the parking brake switch assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I66-6 (PKB) - A42-1 | Always | Below 1 Ω |
| I66-6 (PKB) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
NG