Home › Vehicle Interior › METER / GAUGE / DISPLAY › COMBINATION METER › from 2015.04
RM2030EQ _58 Vehicle Interior _014667 METER / GAUGE / DISPLAY _0074617 COMBINATION METER A

METER / GAUGE / DISPLAY  COMBINATION METER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 62312B 3.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

Hide 55318C 4.REMOVE INSTRUMENT SIDE PANEL

Hide 55431B 5.REMOVE UPPER INSTRUMENT PANEL FINISH PANEL (for RHD)

Hide 55650 6.REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55410C 7.REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 83100 8.REMOVE COMBINATION METER ASSEMBLY

a.
E226414

Remove the 4 screws.


b.
E306607

Disengage the wire harness clamp.


c.

Disconnect the 2 connectors to remove the combination meter assembly.