Home › Power Source / Network › NETWORKING › NETWORK GATEWAY ECU › from 2015.04
RM2030EQ _57 Power Source / Network _014663 NETWORKING _0074574 NETWORK GATEWAY ECU A

NETWORKING  NETWORK GATEWAY ECU  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

When disassembling the network gateway ECU, eliminate static electricity by touching the vehicle body to prevent the components from being damaged.

·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION



PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 89111 3.REMOVE NETWORK GATEWAY ECU

a.
C239503

for LHD:

i.

Disengage the 2 claws and remove the network gateway ECU.



b.
C247828

for RHD:

i.

Disengage the 2 claws and remove the network gateway ECU.