This DTC is stored when a communication error occurs between the navigation receiver assembly and combination meter assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B1324 | Lost Communication with Meter | After the navigation receiver assembly receives a registration information signal, which is sent by the combination meter assembly when the engine switch is turned on (ACC), 1 or more times, the navigation receiver assembly cannot receive the signal for 30 seconds or more. | ·
Combination meter assembly ·
Navigation receiver assembly ·
Harness or connector |
Check if meter / gauge system DTCs are output.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTCs are not output. | A |
| DTCs are output. | B |
A
B
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Disconnect the I178 navigation receiver assembly connector.
Disconnect the I18 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I178-3 (CNH1) - I18-18 (MSCH) | Always | Below 1 Ω |
| I178-4 (CNL1) - I18-19 (MSCL) | Always | Below 1 Ω |
| I178-3 (CNH1) - Body ground | Always | 10 kΩ or higher |
| I178-4 (CNL1) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the combination meter assembly with a new or known good one.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER>REMOVAL
Clear the DTCs.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR
Recheck for DTCs and check that no DTCs are output.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG