Do not replace the spiral cable with sensor sub-assembly with the battery connected and the engine switch on (IG).
Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the battery connected and the engine switch on (IG).
Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.
1.ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
45130
2.REMOVE HORN BUTTON ASSEMBLY
45100
3.REMOVE STEERING WHEEL ASSEMBLY
| *a | Matchmark |
Remove the steering wheel assembly set nut.
Put matchmarks on the steering wheel assembly and steering main shaft.
Disconnect the connectors from the spiral cable sub-assembly and steering wheel assembly.
| *a | Turn |
| *b | Hold |
Using SST, remove the steering wheel assembly.
Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.
84250A
4.REMOVE STEERING PAD SWITCH ASSEMBLY
84610F
5.REMOVE SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)
84523
6.REMOVE NO. 1 SWITCH WIRE
84632
7.REMOVE CRUISE CONTROL MAIN SWITCH
84633
8.REMOVE CRUISE CONTROL SWITCH WIRE
Remove the cruise control switch wire.
45713A
9.REMOVE STEERING SHAKE DAMPER
Remove the 2 screws and steering shake damper from the steering wheel sub-assembly.