Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM › from 2015.04
RM2030EQ _56 Audio / Visual / Telematics _014660 PARK ASSIST / MONITORING _0074560 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  C1AC2  Slave Module Horizontal Axis Misalignment  


DESCRIPTION

This DTC is stored when the angle of the blind spot monitor sensor LH deviates more than the allowable range from the horizontal axis.

HINT:

If drum tester such as a speedometer tester, brake/speedometer combination tester or chassis dynamometer is used with the blind spot monitor main switch (warning canceling switch assembly) on, the blind spot monitor system may store this DTC by mistake.


DTC No. Detection Item DTC Detection Condition Trouble Area
C1AC2 Slave Module Horizontal Axis Misalignment When the blind spot monitor sensor deviates 5 degrees or more from the horizontal axis when the system is activated. Blind spot monitor sensor LH

CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor main switch (warning canceling switch assembly) is on.


PROCEDURE

1.CHECK INSTALLATION CONDITION
a.

Check the installation condition of the blind spot monitor sensor LH.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK

HINT:

Take the appropriate action in accordance with the result.



Result:
Proceed to
NEXT



NEXT

2.PERFORM BEAM AXIS CONFIRMATION
2.PERFORM BEAM AXIS CONFIRMATION

b.

Perform Blind Spot Monitor Beam Axis Confirmation using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK


Result:
Proceed to
OK
NG



OK

END

NG