Home › Steering › STEERING COLUMN › STEERING LOCK SYSTEM › from 2015.04
RM2030EQ _55 Steering _014656 STEERING COLUMN _0077044 STEERING LOCK SYSTEM S

STEERING COLUMN  STEERING LOCK SYSTEM  DIAGNOSTIC TROUBLE CODE CHART  


STEERING LOCK SYSTEM
DTC No. Detection Item DTC Detection Condition Note Link
B2781 Open / Short in Steering Lock ECU One of the following conditions is met (1-trip detection logic (Only output while a malfunction is present and the engine switch is on (IG).)):
·

The steering lock/unlock position sensor is malfunctioning (When both detection switches turn on, the system is determined to be malfunctioning.).

·

The steering lock motor activation circuit has a short circuit.

·

The steering lock motor activation circuit has an open circuit.


No confirmation operation is necessary (monitoring is continuous). Click here
B2782 Power Source Control ECU Malfunction Either condition is met (1-trip detection logic (Only output while a malfunction is present and the engine switch is on (IG).)):
·

The steering lock motor activation command circuit has a short circuit.

·

The steering lock motor activation command circuit has an open circuit.


HINT:

If the power supply signal from the LIN communication line does not match the power supply signal from the direct line, the system is determined to be malfunctioning.


Perform a steering lock/unlock operation. (The steering locks when a door is opened with the shift lever in P and the engine switch off. The steering unlocks when the engine switch is turned on (ACC) or on (IG) while carrying the key.) Click here
B2788 IG2 Signal Malfunction Mismatch between the steering lock ECU IG2 input from the LIN communication system and from the direct line (1-trip detection logic (Only output while a malfunction is present and the engine switch is on (IG).)). No confirmation operation is necessary (monitoring is continuous). Click here