Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › FRAME WIRE
RM2040EQ _51 Engine / Hybrid System _014692 HYBRID / BATTERY CONTROL _0074893 FRAME WIRE A

HYBRID / BATTERY CONTROL  FRAME WIRE  REMOVAL  


PROCEDURE

Hide 2.REMOVE ENGINE ASSEMBLY WITH TRANSAXLE

Hide 77100 3.REMOVE FUEL TANK ASSEMBLY

Hide 4.SEPARATE REAR SEATBACK ASSEMBLY RH

a.

Fold down the rear seatback assembly RH.


Hide 5.REMOVE REAR SIDE SEATBACK ASSEMBLY RH

Hide 64272B 6.REMOVE ROOM PARTITION BOARD LH

Hide G92Q6 7.REMOVE NO. 4 HYBRID BATTERY SHIELD PANEL

Hide 82164C 8.REMOVE NO. 4 FLOOR WIRE

CAUTION:

Wear insulated gloves.


NOTICE:

Insulate the removed terminals with insulating tape.


a.
A259420

Disconnect the 2 connectors.


b.

Disconnect the shielded wire ground.


c.
A259991

Disconnect the wire harness clamp and connector.


d.
A259992

Disengage the 3 claws and push the frame wire out from the floor panel.


e.
A259985

Disconnect the 2 wire harness clamps.


f.
A259986

Disconnect the 2 wire harness clamps and connector.


g.

Remove the 2 nuts.


h.
A259990

Remove the bolt and disconnect the clamp.


i.
A268749

Remove the 2 bolts.


j.
A268748

Remove the nut, clamp and wiring harness clamp bracket.

HINT:

When removing the clamp, break the claw on the clamp. The clamp cannot be reused.



k.

Remove the 5 nuts.

A268750


l.

Disconnect the 3 clamps and remove the No. 4 floor wire.

A268763

HINT:

When removing the clamp, break the claw on the clamp. The clamp cannot be reused.