Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HV RELAY ASSEMBLY
RM2040EQ _51 Engine / Hybrid System _014692 HYBRID / BATTERY CONTROL _0074896 HV RELAY ASSEMBLY A

HYBRID / BATTERY CONTROL  HV RELAY ASSEMBLY  REMOVAL  


PROCEDURE

Hide 6.REMOVE REAR SEAT CUSHION ASSEMBLY

Hide 72693 7.REMOVE REAR SEAT CUSHION LOCK HOOK

Hide 8.SEPARATE REAR SEATBACK ASSEMBLY RH

Hide 9.REMOVE REAR SIDE SEATBACK ASSEMBLY RH

Hide 64272B 10.REMOVE ROOM PARTITION BOARD LH

Hide G92Q6 11.REMOVE NO. 4 HYBRID BATTERY SHIELD PANEL

CAUTION:

Wear insulated gloves.


a.
A259416C02
2.906,0.271 3.094,0.271 false 2.698,0.823 2.979,0.823 false 2.469,1.333 2.271,1.333 false 2.688,1.271 2.875,1.115 2.875,1.115 3.052,1.115 true 3,0.76 3.188,0.99 0.188,0.229 10 false *a 2.177,0.604 2.365,0.833 0.188,0.229 10 false *b 3.115,0.208 3.302,0.438 0.188,0.229 10 false *1 2.104,1.281 2.292,1.51 0.188,0.229 10 false *2 3.115,1.031 3.302,1.26 0.188,0.229 10 false *3
*1 Service Plug Grip
*2 Battery Cover Lock Striker
*3 Button
*a Projection
*b Turn


Using the service plug grip, remove the battery cover lock striker.

HINT:

Insert the projecting part of the service plug grip, and turn the button of the battery cover lock striker counterclockwise to release the lock.



b.
A259419

Remove the bolt, 2 nuts and No. 4 hybrid battery shield panel.


Hide 82164C 12.DISCONNECT NO. 4 FLOOR WIRE

CAUTION:

Wear insulated gloves.


NOTICE:

Insulate the disconnected connectors with insulating tape.


a.
A259420

Disconnect the 2 connectors shown in the illustration.


b.

Disconnect the shielded wire ground and disconnect the No. 4 floor wire.


Hide G920Q 13.REMOVE NO. 1 HYBRID BATTERY SHIELD SUB-ASSEMBLY

CAUTION:

Wear insulated gloves.


a.
A259421

Disconnect the connector and wire harness clamp.


b.
A259429

Remove the bolt, 3 nuts and No. 1 hybrid battery shield sub-assembly.


Hide G92Z0 14.REMOVE HYBRID BATTERY JUNCTION BLOCK ASSEMBLY

CAUTION:

Wear insulated gloves.


NOTICE:

Insulate the disconnected terminals with insulating tape.


a.
A259431

Disengage the claw and disconnect the terminal cover.


b.
A259432

Using an insulated tool, remove the 2 bolts.


c.
A259430

Disconnect the connector shown in the illustration.


d.
A259433

Remove the 3 bolts and hybrid battery junction block assembly.