Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › SERVICE PLUG GRIP
RM2040EQ _51 Engine / Hybrid System _014692 HYBRID / BATTERY CONTROL _0074898 SERVICE PLUG GRIP A

HYBRID / BATTERY CONTROL  SERVICE PLUG GRIP  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:
·

Before inspecting the high voltage system or disconnecting the low voltage connector of the inverter with converter assembly, take safety precautions such as wearing insulated gloves and removing the service plug grip to prevent electrical shocks. After removing the service plug grip, put it in your pocket to prevent other technicians from accidentally reconnecting it while you are working on the high voltage system.

·

After removing the service plug grip, wait for at least 10 minutes before touching any of the highvoltage connectors or terminals. After waiting for 10 minutes, check the voltage at the terminals in the inspection point in the inverter with converter assembly. The voltage should be 0 V before beginning work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION



NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


HINT:

Waiting for at least 10 minutes is required to discharge the high-voltage capacitor inside the inverter with converter assembly.


Hide 64718C 2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER

Hide 3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 64711 4.REMOVE LUGGAGE COMPARTMENT FLOOR MAT

Hide 64717A 5.REMOVE LUGGAGE COMPARTMENT FRONT TRIM COVER

Hide G92QA 6.REMOVE NO. 8 HYBRID VEHICLE BATTERY SHIELD PANEL

a.
A258773

Remove the 2 nuts and No. 8 hybrid vehicle battery shield panel.


Hide G3834 7.REMOVE SERVICE PLUG GRIP

CAUTION:
·

Wear insulating gloves.

·

Remove the service plug grip to interrupt the high voltage circuit at the time of inspection or repair.

·

Keep the removed service plug grip in your pocket to prevent other technicians from accidentally reconnecting it while you are servicing the vehicle.

·

All the high voltage wiring connectors are orange.



a.

Wear insulating gloves and remove the service plug grip after sliding up the lever of the service plug grip as shown in the illustration.

A258774

CAUTION:
·

Keep the removed service plug grip in your pocket to prevent other technicians from accidentally reconnecting it while you are servicing the vehicle.

·

After removing the service plug grip, do not touch the high voltage connectors or terminals for 10 minutes.



HINT:

Waiting for at least 10 minutes is required to discharge the high voltage capacitor inside the inverter with converter assembly.