Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › BATTERY BLOWER
RM2040EQ _51 Engine / Hybrid System _014692 HYBRID / BATTERY CONTROL _0074899 BATTERY BLOWER A

HYBRID / BATTERY CONTROL  BATTERY BLOWER  INSTALLATION  


PROCEDURE

Hide G9230 1.INSTALL BATTERY COOLING BLOWER ASSEMBLY

NOTICE:
·

Be sure not to touch the fan part of the battery cooling blower assembly.

·

Do not lift the battery cooling blower assembly using the wire harness.



a.

Install the battery cooling blower assembly with the 3 nuts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


b.

Connect the connector.


Hide G92D2 2.INSTALL NO. 2 HYBRID BATTERY INTAKE DUCT

a.

Engage the 2 claws to install the No. 2 hybrid battery intake duct.

NOTICE:

Ensure that the duct is installed securely.



b.

Install the clip.


Hide G92D1 3.INSTALL NO. 1 HYBRID BATTERY INTAKE DUCT

a.

Install the No. 1 hybrid battery intake duct with the 3 clips.

NOTICE:

Ensure that the duct is installed securely.



Hide 4.INSTALL REAR SIDE SEATBACK ASSEMBLY LH

Hide 72693 6.INSTALL REAR SEAT CUSHION LOCK HOOK

Hide 7.INSTALL REAR SEAT CUSHION ASSEMBLY

Hide 64717A 8.INSTALL LUGGAGE COMPARTMENT FRONT TRIM COVER

Hide 64711 9.INSTALL LUGGAGE COMPARTMENT FLOOR MAT