Home › Engine / Hybrid System › 2AR-FXE EMISSION CONTROL › EGR VALVE
RM2040EQ _51 Engine / Hybrid System _014695 2AR-FXE EMISSION CONTROL _0074915 EGR VALVE A

2AR-FXE EMISSION CONTROL  EGR VALVE  INSTALLATION  


PROCEDURE

Hide 25620 1.INSTALL EGR VALVE ASSEMBLY

HINT:

After replacing the EGR valve assembly, perform the "Inspection After Repair".

Click hereEngine / Hybrid System>2AR-FXE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION


a.

Install 2 new gaskets to the intake manifold and No. 1 EGR pipe.


b.

Type A:

i.

Temporarily install the EGR valve assembly to the intake manifold with the 4 bolts.


ii.

Temporarily install the 2 nuts to the EGR valve assembly.


iii.

Tighten the 4 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)



c.

Type B:

i.

Temporarily install the EGR valve assembly to the intake manifold with the 3 bolts.


ii.

Temporarily install the 2 nuts to the EGR valve assembly.


iii.

Tighten the 3 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)



d.

Using a 12 mm deep socket wrench, tighten the 2 nuts.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)


e.

Using a 10 mm deep socket wrench, install the bolt to the EGR valve assembly.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


f.

Connect the 2 water by-pass hoses to the EGR valve assembly and slide the 2 clips to secure them.


g.

Connect the EGR valve assembly connector.


Hide 2.INSTALL AIR CLEANER CAP SUB-ASSEMBLY

Hide 12601B 3.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 5.INSPECT FOR COOLANT LEAK (for Engine)