1.DRAIN COOLANT (for Engine)
12601B
2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
3.REMOVE AIR CLEANER CAP SUB-ASSEMBLY
25620
4.REMOVE EGR VALVE ASSEMBLY
Disconnect the EGR valve assembly connector.
Slide the 2 clips and disconnect the 2 water by-pass hoses from the EGR valve assembly.
Using a 10 mm deep socket wrench, remove the bolt from the EGR valve assembly.
Using a 12 mm deep socket wrench, remove the 2 nuts from the EGR valve assembly.
Type A:
Remove the 4 bolts and EGR valve assembly from the intake manifold.
Type B:
Remove the 3 bolts and EGR valve assembly from the intake manifold.
Remove the 2 gaskets from the intake manifold and No. 1 EGR pipe.