Home › Drivetrain › P314 HYBRID TRANSMISSION / TRANSAXLE › INPUT SHAFT OIL SEAL
RM2040EQ _52 Drivetrain _014701 P314 HYBRID TRANSMISSION / TRANSAXLE _0074950 INPUT SHAFT OIL SEAL A

P314 HYBRID TRANSMISSION / TRANSAXLE  INPUT SHAFT OIL SEAL  REPLACEMENT  


PROCEDURE

Hide 30900 1.REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY

Hide 35710A 2.REMOVE INPUT SHAFT TYPE T OIL SEAL

a.
C243619
1.698,1.156 1.281,0.438 1.281,0.438 1.156,0.438 true 0.979,0.354 1.146,0.51 0.167,0.156 10 false *a
*a Vinyl Tape


Using a screwdriver with its tip taped, remove the input shaft type T oil seal.

NOTICE:

When removing the input shaft type T oil seal, make sure not to damage the input shaft or hybrid vehicle transaxle housing.



Hide 35710A 3.INSTALL INPUT SHAFT TYPE T OIL SEAL

a.
C243620
2.156,2.021 2.438,2.99 2.438,2.99 2.531,2.99 true 2.573,2.917 2.927,3.104 0.354,0.188 10 false SST

Coat the lip of a new input shaft type T oil seal with MP grease.


b.

Using SST and a hammer, tap in the input shaft type T oil seal.

SST
09388-40010  

Oil seal installation depth:

1.0 to 1.8 mm (0.0394 to 0.0709 in.)


NOTICE:
·

Ensure that no foreign matter adheres to the oil seal lip.

·

Ensure that the oil seal is not at an angle.




Hide 30900 4.INSTALL HYBRID VEHICLE TRANSAXLE ASSEMBLY