1.DRAIN COOLANT (for Inverter)
2.REMOVE NO. 2 MOTOR WATER JACKET COVER ASSEMBLY
Remove the 5 bolts.
Insert the blade of an oil pan seal cutter between the transaxle housing. Cut through the applied sealer and remove the No. 2 motor water jacket cover assembly.
Be careful not to damage the contact surfaces of the transaxle housing where the motor water jacket cover is installed.
30900
3.REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY
12311A
4.REMOVE FRONT ENGINE MOUNTING BRACKET
33823
5.REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET
35151J
6.REMOVE AUTOMATIC TRANSMISSION CASE COVER
Remove the 2 bolts, clip and automatic transmission case cover from the hybrid vehicle transaxle assembly.
7.REMOVE NO. 1 MOTOR WATER JACKET COVER ASSEMBLY
Remove the 8 bolts.
Insert the blade of an oil pan seal cutter between the transaxle housing. Cut through the applied sealer and remove the No. 1 motor water jacket cover assembly.
Be careful not to damage the contact surfaces of the transaxle housing where the motor water jacket cover is installed.