Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY
RM2040EQ _52 Drivetrain _014702 DRIVE SHAFT / PROPELLER SHAFT _0074955 FRONT DRIVE SHAFT ASSEMBLY A

DRIVE SHAFT / PROPELLER SHAFT  FRONT DRIVE SHAFT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEELS

Hide 53852K 2.REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

Hide 51442C 3.REMOVE ENGINE UNDER COVER LH

Hide 53851Z 4.REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

Hide 51441C 5.REMOVE ENGINE UNDER COVER RH

Hide 53737B 6.REMOVE FRONT FENDER APRON SEAL LH

Hide 53736 7.REMOVE FRONT FENDER APRON SEAL RH

Hide 43502H 9.REMOVE FRONT AXLE SHAFT NUT

a.
C167528N07
2.344,1.052 2.594,1.052 2.594,1.052 2.594,1.219 false 2.458,1.229 2.906,1.552 0.448,0.323 10 false SST

Using SST and a hammer, release the staked part of the front axle shaft nut.

SST
09930-00010  

NOTICE:

Loosen the staked part of the nut completely, otherwise the threads of the drive shaft may be damaged.



b.

While applying the brakes, remove the front axle shaft nut.


Hide 48810 10.SEPARATE FRONT STABILIZER LINK ASSEMBLY

Hide 89543 11.SEPARATE FRONT SPEED SENSOR

Hide 45470 12.SEPARATE TIE ROD ASSEMBLY

Hide 48069 13.SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY

Hide 14.SEPARATE FRONT DRIVE SHAFT ASSEMBLY

Hide 43420 15.REMOVE FRONT DRIVE SHAFT ASSEMBLY LH

a.
C239400N03
1.438,0.896 1.438,0.24 1.438,0.24 0.385,0.24 false 0.958,0.688 0.958,0.25 false 0.094,0.156 0.667,0.396 0.573,0.24 10 false SST

Using SST, remove the front drive shaft assembly LH.

SST
09520-00031  
09520-01010  

NOTICE:
·

Do not damage the hybrid vehicle transaxle assembly type T oil seal.

·

Do not damage the front axle inboard joint boot.

·

Do not drop the front drive shaft assembly LH.




Hide 43410 16.REMOVE FRONT DRIVE SHAFT ASSEMBLY RH

a.
C239399

Separate the bearing bracket hole snap ring from the drive shaft bearing bracket.


b.

Remove the bolt and front drive shaft assembly RH from the drive shaft bearing bracket.

NOTICE:
·

Do not damage the hybrid vehicle transaxle assembly type T oil seal.

·

Do not damage the front axle inboard joint boot.

·

Do not drop the front drive shaft assembly RH.




c.

Remove the bearing bracket hole snap ring from the front drive shaft assembly RH.


Hide 43420G 17.REMOVE FRONT DRIVE SHAFT HOLE SNAP RING LH

a.
C057543

Using a screwdriver, remove the front drive shaft hole snap ring LH.