Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL › 2012.02–2015.04
RM2040EQ _54 Brake _014709 BRAKE SYSTEM (OTHER) _0074987 BRAKE PEDAL A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL  INSTALLATION  


PROCEDURE

Hide 1.INSTALL BRAKE PEDAL SUPPORT ASSEMBLY

a.

Install the brake pedal support assembly with the 4 nuts.

Torque:
13 N*m (131 kgf*cm, 9 ft.*lbf)


b.

Engage the clamp to install the wire harness to the brake pedal support assembly.


c.

Engage the 3 clamps to install the wire harness to the brake pedal support assembly.


Hide 47101A 2.INSTALL BRAKE PEDAL RETURN SPRING

a.
C243047

Install the brake pedal return spring to the brake pedal support assembly.

NOTICE:

Attach the bottom part of the brake pedal return spring first, making sure that the open part of the hook is facing the rear of the vehicle. Attach the top part of the brake pedal return spring second, making sure that the open part of the hook is facing the front of the vehicle.



Hide 47264A 3.INSTALL PUSH ROD PIN

a.
C259401C02
1.542,0.521 1.635,0.646 0.094,0.125 6 .
V100145

Lithium Soap Base Glycol Grease


Apply lithium soap base glycol grease to the push rod pin.


b.

Connect the brake master cylinder push rod clevis to the brake pedal support assembly with the push rod pin, and install a new clip as shown in the illustration.

NOTICE:
·

Be sure to insert the pin with its clip end facing the outside of the vehicle.

·

Make sure that the brake master cylinder push rod clevis moves sideway.




Hide 84345 4.INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER

Hide 84340 5.INSTALL STOP LIGHT SWITCH ASSEMBLY

Hide 89940 6.INSTALL AFS ECU (w/ Automatic High Beam System)

Hide 89510D 7.INSTALL BRAKE PEDAL STROKE SENSOR ASSEMBLY

Hide 8.INSTALL INSTRUMENT PANEL REINFORCEMENT ASSEMBLY WITH AIR CONDITIONING UNIT

Hide 9.INSPECT AND ADJUST BRAKE PEDAL