Home › Brake › BRAKE (FRONT) › FRONT BRAKE
RM2040EQ _54 Brake _014710 BRAKE (FRONT) _0074990 FRONT BRAKE A

BRAKE (FRONT)  FRONT BRAKE  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.

·

While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch is turned on. Therefore, even if only brake pads are to be removed and installed, be sure to perform the Disable Brake Control procedure and disconnect the cable from the negative (-) terminal of the auxiliary battery before beginning work.



HINT:
·

Use the same procedure for the LH side and RH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

Hide 55702A 3.REMOVE FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY

Hide 4. DISABLE BRAKE CONTROL

Hide 5.REMOVE FRONT WHEEL

Hide 6.DRAIN BRAKE FLUID

NOTICE:

If brake fluid leaks onto any painted surface, immediately wash it off.


Hide 47313A 7.SEPARATE FRONT FLEXIBLE HOSE

a.
C238481

Remove the union bolt and gasket, and separate the front flexible hose from the disc brake cylinder assembly.


Hide 47750 8.REMOVE DISC BRAKE CYLINDER ASSEMBLY

a.
C239567C05
1.031,1.427 1.365,1.75 0.333,0.323 10 false *a 0.896,0.396 1.24,0.688 0.344,0.292 10 false *b
*a Hold
*b Turn


Hold the front disc brake cylinder slide pin, and remove the 2 bolts and disc brake cylinder assembly.


Hide 04465 9.REMOVE FRONT DISC BRAKE PAD KIT

a.
C238483

Remove the 2 anti-squeal springs from the front disc brake pads.


b.
C238484

Remove the 2 front disc brake pads with front anti-squeal shim kit from the front disc brake cylinder mounting.


Hide 04945 10.REMOVE FRONT ANTI-SQUEAL SHIM KIT

a.
C239559

Remove the front disc brake anti-squeal shim from each front disc brake pad.


b.
C239560

Remove the front disc brake pad wear indicator plate from each front disc brake pad.


Hide 04947 11.REMOVE FRONT DISC BRAKE FITTING KIT

a.
C238485C07
1.844,1.76 2.438,1.76 false 2.031,0.667 3.031,0.667 false 1.344,0.625 0.479,0.625 false 1.25,1.646 0.75,1.646 false 3.073,0.573 3.365,0.792 0.292,0.219 10 false *1 2.49,1.667 2.75,1.906 0.26,0.24 10 false *2 0.583,1.552 0.823,1.771 0.24,0.219 10 false *1 0.313,0.531 0.573,0.792 0.26,0.26 10 false *2
*1 Front No. 1 Disc Brake Pad Support Plate
*2 Front No. 2 Disc Brake Pad Support Plate


Remove the 2 front No. 1 disc brake pad support plates and 2 front No. 2 disc brake pad support plates from the front disc brake cylinder mounting.

NOTICE:

Each front disc brake pad support plate has a different shape. Be sure to put an identification mark on each front disc brake pad support plate so that it can be reinstalled to its original position.



Hide 47715A 12.REMOVE FRONT DISC BRAKE CYLINDER SLIDE PIN

a.
C238486

Remove the front disc brake cylinder slide pin from the front disc brake cylinder mounting.


Hide 47715D 13.REMOVE FRONT NO. 2 DISC BRAKE CYLINDER SLIDE PIN

a.
C238487

Remove the front No. 2 disc brake cylinder slide pin from the front disc brake cylinder mounting.


Hide 47769 14.REMOVE FRONT DISC BRAKE CYLINDER SLIDE BUSHING

a.
C210924C19
2.323,1.385 2.323,0.99 2.323,0.99 2.531,0.99 false 2.563,0.896 2.802,1.125 0.24,0.229 10 false *1
*1 Vinyl Tape


Using a screwdriver with its tip wrapped with vinyl tape, remove the front disc brake cylinder slide bushing from the front No. 2 disc brake cylinder slide pin.

NOTICE:

Do not damage the front No. 2 disc brake cylinder slide pin.



Hide 47722 15.REMOVE FRONT DISC BRAKE CYLINDER MOUNTING

a.
C238488

Remove the 2 bolts and front disc brake cylinder mounting from the steering knuckle.


Hide 16.REMOVE FRONT DISC BRAKE BUSHING DUST BOOT

a.
C238489

Secure the front disc brake cylinder mounting in a vise.


b.

Using a screwdriver and a plastic hammer, remove the 2 front disc brake bushing dust boots.


Hide 43512 17.REMOVE FRONT DISC

a.
C238490C09
2.302,1.281 3.052,1.208 3.052,1.208 2.281,1.208 false 3.073,1.125 3.313,1.385 0.24,0.26 10 false *a
*a Matchmark


Put matchmarks on the front disc and the front axle hub.


b.

Remove the front disc.