Home › Brake › BRAKE (FRONT) › FRONT BRAKE FLEXIBLE HOSE
RM2040EQ _54 Brake _014710 BRAKE (FRONT) _0074991 FRONT BRAKE FLEXIBLE HOSE A

BRAKE (FRONT)  FRONT BRAKE FLEXIBLE HOSE  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

If the left and right hoses are disconnected at the same time, be sure to place a mark on each hose to indicate its installation position.


HINT:
·

Use the same procedure for the LH side and RH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

Hide 55702A 3.REMOVE FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY

Hide 4. DISABLE BRAKE CONTROL

Hide 5.REMOVE FRONT WHEEL

Hide 6.DRAIN BRAKE FLUID

NOTICE:

If brake fluid leaks onto any painted surface, immediately wash it off.


Hide 47313A 7.REMOVE FRONT FLEXIBLE HOSE

a.
C238481

Remove the union bolt and gasket, and separate the front flexible hose from the front disc brake cylinder assembly.


b.
C238495C08
1.823,1.052 2.042,1.052 false 2.083,0.969 2.323,1.208 0.24,0.24 10 false *1
*1 Clip


Using a union nut wrench, disconnect the brake line while holding the front flexible hose with a wrench.

NOTICE:
·

Do not bend or damage the brake line.

·

Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting points.




c.

Remove the clip.


d.
C238496

Remove the bolt and front flexible hose from the front shock absorber assembly.