Home › Brake › BRAKE (REAR) › REAR BRAKE
RM2040EQ _54 Brake _014711 BRAKE (REAR) _0074992 REAR BRAKE A

BRAKE (REAR)  REAR BRAKE  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.

·

While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch is turned on. Therefore, even if only brake pads are to be removed and installed, be sure to perform the Disable Brake Control procedure and disconnect the cable from the negative (-) terminal of the auxiliary battery before beginning work.



HINT:
·

Use the same procedure for the LH side and RH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

Hide 55702A 3.REMOVE FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY

Hide 4. DISABLE BRAKE CONTROL

Hide 5.REMOVE REAR WHEEL

Hide 6.DRAIN BRAKE FLUID

NOTICE:

If brake fluid leaks onto any painted surface, immediately wash it off.


Hide 47319F 7.SEPARATE REAR FLEXIBLE HOSE

a.
C243121

Remove the union bolt and gasket, and separate the rear flexible hose from the rear disc brake cylinder assembly.


Hide 47850 8.REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY

a.
C239569C05
2.271,0.438 2.656,0.781 0.385,0.344 10 false *b 2.75,1.917 3.146,2.302 0.396,0.385 10 false *a
*a Hold
*b Turn


Hold the rear disc brake cylinder slide pin, and remove the 2 bolts and rear disc brake cylinder assembly.


Hide 04466 9.REMOVE REAR DISC BRAKE PAD

a.
C238499

Remove the 2 rear disc brake pads with rear disc brake anti-squeal shim kit from the disc brake cylinder mounting.


Hide 04946 10.REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM KIT

a.
C239558

Remove the rear disc brake anti-squeal shim from each rear disc brake pad.


b.
C239557

Remove the rear disc brake pad wear indicator plate from each rear disc brake pad.


Hide 47716A 11.REMOVE REAR DISC BRAKE PAD SUPPORT PLATE

a.
C238500

Remove the 2 rear disc brake pad support plates from the disc brake cylinder mounting.


Hide 47814 12.REMOVE REAR DISC BRAKE CYLINDER SLIDE PIN (for Upper Side)

a.
C243122

Remove the rear disc brake cylinder slide pin from the disc brake cylinder mounting.


Hide 47814 13.REMOVE REAR DISC BRAKE CYLINDER SLIDE PIN (for Lower Side)

a.
C243123

Remove the rear disc brake cylinder slide pin from the disc brake cylinder mounting.


Hide 14.REMOVE REAR DISC BRAKE CYLINDER SLIDE BUSHING

a.
C210924C20
2.365,1.406 2.365,1.01 2.365,1.01 2.573,1.01 false 2.573,0.917 2.865,1.167 0.292,0.25 10 false *1
*1 Vinyl Tape


Using a screwdriver with its tip wrapped with vinyl tape, remove the rear disc brake cylinder slide bushing from the rear disc brake cylinder slide pin.

NOTICE:

Do not damage the rear disc brake cylinder slide pin.



Hide 15.REMOVE REAR DISC BRAKE BUSHING DUST BOOT

a.
C243124

Remove the 2 rear disc brake bushing dust boots from the disc brake cylinder mounting.


Hide 47722A 16.REMOVE DISC BRAKE CYLINDER MOUNTING

a.
C243125

Remove the 2 bolts and disc brake cylinder mounting.


Hide 42491 17.REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG

a.

Remove the parking brake shoe adjusting hole plug.


Hide 42431 18.REMOVE REAR DISC

a.
C238505C09
1.948,1.281 2.938,1.198 2.938,1.198 1.927,1.208 false 2.969,1.104 3.24,1.375 0.271,0.271 10 false *a
*a Matchmark


Put matchmarks on the rear disc and the rear axle hub.


b.
C201774

Release the parking brake and remove the rear disc.

HINT:

If the disc cannot be removed easily, use a screwdriver to turn the shoe adjuster as shown in the illustration in order to contract the parking brake shoes.