Home › Steering › STEERING GEAR / LINKAGE › STEERING GEAR
RM2040EQ _55 Steering _014715 STEERING GEAR / LINKAGE _0075006 STEERING GEAR A

STEERING GEAR / LINKAGE  STEERING GEAR  INSTALLATION  


PROCEDURE

Hide 45470 1.INSTALL TIE ROD ASSEMBLY LH

a.
C238518C12
1.24,1.031 1.24,1.552 false 1.021,1.031 1.021,1.25 1.021,1.25 1.24,1.25 false 1.156,1.573 1.417,1.823 0.26,0.25 10 false *a
*a Matchmark


Install the lock nut and tie rod assembly LH to the steering rack end sub-assembly until the matchmarks are aligned.

HINT:

After adjusting the front wheel alignment, tighten the lock nut.



Hide 45460 2.INSTALL TIE ROD ASSEMBLY RH

HINT:

Perform the same procedure as for the LH side.


Hide 3.INSTALL STEERING LINK ASSEMBLY

a.

Install the steering link assembly with the 2 bolts and 2 nuts.

Torque:
70 N*m (714 kgf*cm, 52 ft.*lbf)

NOTICE:
·

Keep the nut from rotating while turning the bolt because the nut has its own stopper.

·

Make sure to tighten the bolts starting from the pinion shaft side.




Hide 48811 4.INSTALL FRONT STABILIZER BAR

Hide 48829A 5.INSTALL FRONT NO. 1 STABILIZER BRACKET LH

Hide 48824A 6.INSTALL FRONT NO. 1 STABILIZER BRACKET RH

HINT:

Perform the same procedure as for the LH side.


Hide 7.INSTALL ENGINE ASSEMBLY WITH TRANSAXLE

Hide 45470 8.CONNECT TIE ROD ASSEMBLY LH

a.

Connect the tie rod assembly LH to the steering knuckle with the nut.

Torque:
49 N*m (500 kgf*cm, 36 ft.*lbf)


b.

Install a new cotter pin.

NOTICE:

Further tighten the nut up to 60° if the holes for the cotter pin are not aligned.



Hide 45460 9.CONNECT TIE ROD ASSEMBLY RH

HINT:

Perform the same procedure as for the LH side.


Hide 45220 10.CONNECT STEERING INTERMEDIATE SHAFT ASSEMBLY

a.
C243088C05
1.792,0.917 2.375,1.104 2.375,1.104 1.813,1 false 2.375,1.01 2.615,1.208 0.24,0.198 10 false *a
*a Matchmark


Align the matchmarks and install the steering intermediate shaft to the steering link assembly.


b.

Install the bolt.

Torque:
35 N*m (360 kgf*cm, 26 ft.*lbf)


Hide 11.INSTALL FRONT WHEELS

Torque:
103 N*m (1049 kgf*cm, 76 ft.*lbf)

Hide 12.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

Hide 13.INSPECT STEERING WHEEL CENTER POINT