Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › CLEARANCE SONAR MAIN SWITCH
RM2040EQ _56 Audio / Visual / Telematics _014718 PARK ASSIST / MONITORING _0075034 CLEARANCE SONAR MAIN SWITCH A

PARK ASSIST / MONITORING  CLEARANCE SONAR MAIN SWITCH  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 64718C 2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER

Hide 3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 62311B 4.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH

Hide 55317A 5.REMOVE INSTRUMENT SIDE PANEL RH

Hide 55431B 6.REMOVE UPPER INSTRUMENT PANEL FINISH PANEL

Hide 55670 7.REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55410C 8.REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 84490A 9.REMOVE BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY

a.
E244920

Disengage the 2 claws and remove the back sonar or clearance sonar switch assembly.