Home › Vehicle Interior › DOOR LOCK › REAR DOOR LOCK
RM2040EQ _58 Vehicle Interior _014722 DOOR LOCK _0075047 REAR DOOR LOCK A

DOOR LOCK  REAR DOOR LOCK  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LH side and RH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 69770B 1.INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY

Hide 69730D 2.INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

Hide 69050A 3.INSTALL REAR DOOR LOCK WITH MOTOR ASSEMBLY

NOTICE:
·

When reusing the removed rear door lock with motor assembly, replace the door lock wiring harness seal on the connector with a new one.

·

Do not allow grease or dust to adhere to the door lock wiring harness seal surface of the connector.

·

Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water intrusion. This may result in a malfunction of the rear door with motor lock assembly.



a.

Apply MP grease to the sliding parts of the rear door lock with motor assembly.


b.

When reusing the rear door with motor lock assembly:

i.
B275214

Install a new door lock wiring harness seal to the rear door lock with motor assembly.



c.
B275213C05
2.208,2.521 1.948,2.521 true 2.219,2.427 2.417,2.604 0.198,0.177 10 true *1
*1 Release Plate


Insert the rear door lock with motor assembly to the rear door outside handle release plate, and set it to the rear door panel.


d.

Make sure that the rear door outside handle frame release plate is securely connected to the rear door lock with motor assembly.


e.

Using a T30 "TORX" socket wrench, install the rear door lock with motor assembly with the 3 screws.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


Hide 68103 4.INSTALL REAR DOOR GLASS SUB-ASSEMBLY

Hide 68123B 5.INSTALL REAR DOOR QUARTER WINDOW GLASS

a.
B287025

Install the rear door quarter window glass in the direction indicated by the arrow in the illustration.


Hide 67407F 6.INSTALL REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY

Hide 68142C 7.INSTALL REAR DOOR GLASS RUN

Hide 67841E 9.INSTALL REAR DOOR SERVICE HOLE COVER

Hide 68173B 10.INSTALL REAR DOOR INNER GLASS WEATHERSTRIP

Hide 67603 11.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 74250 12.INSTALL REAR ARMREST ASSEMBLY

Hide 13.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

Hide 69283A 14.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

Hide 15.CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 64718C 16.INSTALL LUGGAGE TRIM SERVICE HOLE COVER

Hide 17.INITIALIZE POWER WINDOW CONTROL SYSTEM