Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
64718C
2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER
3.DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
69283A
4.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG
5.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
74250
6.REMOVE REAR ARMREST ASSEMBLY
67603
7.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
68173B
8.REMOVE REAR DOOR INNER GLASS WEATHERSTRIP
67841E
9.REMOVE REAR DOOR SERVICE HOLE COVER
67871
10.DISCONNECT REAR DOOR WEATHERSTRIP
68142C
11.REMOVE REAR DOOR GLASS RUN
67407F
12.REMOVE REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY
68123B
13.REMOVE REAR DOOR QUARTER WINDOW GLASS
Remove the rear door quarter window glass as shown in the illustration.
68103
14.REMOVE REAR DOOR GLASS SUB-ASSEMBLY
69050A
15.REMOVE REAR DOOR LOCK WITH MOTOR ASSEMBLY
| *1 | Release Plate |
Using a T30 "TORX" socket wrench, remove the 3 screws.
Move the rear door lock with motor assembly downward and pull the release plate out of the rear door outside handle frame.
When reusing the rear door lock with motor assembly:
Remove the door lock wiring harness seal from the rear door lock with motor assembly.
69730D
16.REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY
69770B
17.REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY