Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM
RM2040EQ _58 Vehicle Interior _014725 METER / GAUGE / DISPLAY _0075073 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Hybrid System Indicator Malfunction  


DESCRIPTION

A hybrid system indicator (eco zone indicator) is adopted for this vehicle. In this circuit, the meter ECU receives the hybrid system indicator level signal from the power management control ECU via the CAN communication line. The meter ECU controls the operation of the hybrid system indicator according to the hybrid system indicator level signal received from the power management control ECU via the CAN communication line.

WIRING DIAGRAM

E143765E96
0.24,3.125 1.479,3.521 1.24,0.396 10 false Power Management Control ECU 2.948,3.146 4.896,3.51 1.948,0.365 10 false : CAN Communication Line 5.292,3.094 7.156,3.427 1.865,0.333 10 false Combination Meter Assembly

PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Check if CAN communication DTCs are output.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM


Result:
Result Proceed to
DTCs are not output. A
DTCs are output. B



A

2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (HV SYSTEM INDICATOR)

B

2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (HV SYSTEM INDICATOR)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the intelligent tester on.


d.

Enter following menus: Body / Combination Meter / Active Test.


e.

Check the operation by referring to the table below.

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
HV System Indicator HV system indicator MIN, -50, 0, 100, 200, 300, 400, MAX -
Body Electrical > Combination Meter > Active Test
Tester Display
HV System Indicator
50004 122 110
OK:

Hybrid system indicator indication is normal.



Result:
Proceed to
OK
NG



OK

3.READ VALUE USING INTELLIGENT TESTER (HV SYSTEM INDICATOR)

NG

REPLACE COMBINATION METER ASSEMBLY

3.READ VALUE USING INTELLIGENT TESTER (HV SYSTEM INDICATOR)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / Combination Meter / Data List.


e.

Check the values by referring to the table below.

Body Electrical > Combination Meter > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
HV System Indicator Hybrid system indicator value Min.: -512, Max.: 511 -512 to 511 -
Body Electrical > Combination Meter > Data List
Tester Display
HV System Indicator
50003 122 88
OK:

Hybrid system indicator value displayed on the intelligent tester is almost the same as hybrid system indicator indication.



Result:
Proceed to
OK
NG



OK

4.REPLACE COMBINATION METER ASSEMBLY

NG

4.REPLACE COMBINATION METER ASSEMBLY
a.

Replace the combination meter assembly with a new or a known good one.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER>REMOVAL

OK:

The operation of the hybrid system indicator returns to normal.



Result:
Proceed to
OK
NG



OK

END

NG

REPLACE POWER MANAGEMENT CONTROL ECU