88515
1.INSTALL COOLER EXPANSION VALVE
Apply sufficient compressor oil to 2 new O-rings and the fitting surfaces of the cooler expansion valve.
ND-OIL 11 or equivalent
Install 2 new O-rings to the No. 1 cooler evaporator sub-assembly.
Using a 4 mm hexagon wrench, install the cooler expansion valve with the 2 hexagon bolts.
88710E
2.CONNECT AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY
88704
3.CONNECT SUCTION HOSE SUB-ASSEMBLY
Remove the vinyl tape from the hose.
Sufficiently apply compressor oil to a new O-ring and the fitting surface of the suction hose sub-assembly.
ND-OIL 11 or equivalent
Install the O-ring to the suction hose sub-assembly.
Rotate the hook connector in the direction indicated by the arrow in the illustration.
Insert the pipe joint into the cooler expansion valve securely and install the bolt.
55702A
4.INSTALL FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY
5.INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
6.CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT
7.WARM UP COMPRESSOR
8.INSPECT FOR REFRIGERANT LEAK