Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR(for Front Door)
RM2040EQ _59 Vehicle Exterior _014733 WINDOW / GLASS _0075138 POWER WINDOW REGULATOR MOTOR(for Front Door) A

WINDOW / GLASS  POWER WINDOW REGULATOR MOTOR(for Front Door)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the RH and LH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 85720D 2.INSTALL FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY

Hide 3.INSTALL FRONT DOOR WINDOW REGULATOR ASSEMBLY

Hide 68101 4.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

Hide 67831 5.INSTALL FRONT DOOR SERVICE HOLE COVER

Hide 68171B 6.INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP

Hide 67601 7.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 81911B 8.INSTALL REFLEX REFLECTOR

Hide 74210 9.INSTALL FRONT ARMREST ASSEMBLY

Hide 10.INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

Hide 11.INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

Hide 67491A 12.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH

Hide 69283 13.INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

Hide 14.CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 15.INSTALL LUGGAGE TRIM SERVICE HOLE COVER

Hide 16.INITIALIZE POWER WINDOW CONTROL SYSTEM