When the front doors are closed, each power window regulator motor assembly can control its power window operation for approximately 43 seconds after the power switch is turned from on (IG) to off by receiving operation permission signals from the main body ECU (multiplex network body ECU).
However, when approximately 43 seconds have elapsed, or the driver door or front passenger door is opened within approximately 43 seconds of the power switch being turned off, the power window regulator motor assembly stops operating.
During an auto operation, when 43 seconds have passed and key-off operation is prohibited, the window continues the operation until the auto operation is completed.
The power window control system uses a LIN communication system. Inspect the communication function by following How to Proceed with Troubleshooting (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING). Troubleshoot the power window control system after confirming that the communication system is functioning properly.
Check that the manual up and down functions using the power window regulator master switch assembly and power window regulator switch assembly can operate all the power windows.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK
Manual up and down functions are normal.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check that the remote up and down functions using the power window regulator master switch assembly can operate all the power windows.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK
Remote up and down functions are normal.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check the power window operation function after the power switch is turned off.
| Result | Proceed to |
|---|---|
| When power window can still be operated even after opening driver door or front passenger door within approximately 43 seconds of power switch being turned off | A |
| When power window can still be operated even after approximately 43 seconds have elapsed after power switch is turned off (for All Doors) | B |
| When power window can still be operated even after approximately 43 seconds have elapsed after power switch is turned off (for Driver Door) | C |
| When power window can still be operated even after approximately 43 seconds have elapsed after power switch is turned off (Front Passenger Door, Rear LH Door or Rear RH Door) | D |
A
B
C
D
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
Read the Data List according to the display on the intelligent tester.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| FR Door Courtesy SW | Front door courtesy light switch RH | ON or OFF | ON: Front door RH open
OFF: Front door RH closed |
- |
| FL Door Courtesy SW | Front door courtesy light switch LH | ON or OFF | ON: Front door LH open
OFF: Front door LH closed |
- |
| Tester Display |
|---|
| FR Door Courtesy SW |
| FL Door Courtesy SW |
On the intelligent tester screen, ON or OFF is displayed accordingly.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the main body ECU (multiplex network body ECU).
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Check the power window operation function after the power switch is turned off.
The power window control system operates normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG