1. PRECAUTION (w/ Navigation System)
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
64718C
2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER (w/ Navigation System)
3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL (w/ Navigation System)
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
4.REMOVE REAR CONSOLE BOX ASSEMBLY
5.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
55660
6.REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY
58916
7.REMOVE BOX BOTTOM MAT
58804A
8.REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
9.REMOVE RADIO RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (w/o Navigation System)
10.REMOVE NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (w/ Navigation System)
55510F
11.REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY
89120A
12.REMOVE AUTOMATIC LIGHT CONTROL SENSOR
Disengage the 2 claws and remove the automatic light control sensor from the No. 1 speaker opening cover assembly.