Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT DOOR BELT MOULDING › 2012.02–2015.04
RM2040EQ _59 Vehicle Exterior _014740 EXTERIOR PANELS / TRIM _0075193 FRONT DOOR BELT MOULDING A

EXTERIOR PANELS / TRIM  FRONT DOOR BELT MOULDING  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 64718C 2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER

Hide 3.DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 4.REMOVE MIRROR SUB-ASSEMBLY WITH COVER

Hide 67832 5.REMOVE FRONT DOOR SERVICE HOLE COVER

HINT:

Use the same procedure for the RH side and LH side.

Click hereVehicle Exterior>DOOR / HATCH>FRONT DOOR>DISASSEMBLY


Hide 68102 6.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

HINT:

Use the same procedure for the RH side and LH side.

Click hereVehicle Exterior>DOOR / HATCH>FRONT DOOR>DISASSEMBLY


Hide 75720 7.REMOVE FRONT DOOR BELT MOULDING ASSEMBLY

a.
B280066C08
2.198,1.521 1.635,1.094 true 2.24,1.458 2.531,1.719 0.292,0.26 10 false *1
*1 Protective Tape


Put protective tape around the front door belt moulding assembly.


b.
B280067C09
2.823,0.844 1.99,0.771 false 2.865,0.781 3.156,1.031 0.292,0.25 10 false *1
*1 Protective Tape


Using a screwdriver with the tip wrapped with protective tape, disengage the 6 claws and remove the front door belt moulding assembly.

HINT:

Tape the screwdriver tip before use.