If air bleeding has not been performed, the skid control ECU stores DTC C1451/72 to prevent the entry of air due to pump motor operation.
DTC C1451/72 is stored when Invalid Mode is selected, the system will not return to normal until the air bleeding procedure is performed.
| DTC No. | Detection Item | INF Code | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|---|
| C1451/72 | Motor Drive Permission Malfunction | - | Air bleeding has not been performed. | ·
Brake fluid leaks ·
Air bleeding not performed |
Electronically controlled brake system DTC |
Check that the brake fluid level is sufficient.
Brake fluid level is sufficient.
If the fluid level drops, check for fluid leaks, and repair as necessary.
If no fluid leaks exist, add and adjust the fluid.
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID>ON-VEHICLE INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Bleed the air from the brake system.
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID>BLEEDING
If air bleeding has been performed, this DTC will be cleared.
| Proceed to |
|---|
| NEXT |
NEXT
Check if the same DTC is output.
| Result | Proceed to |
|---|---|
| DTC C1451/72 is output. | A |
| DTC C1451/72 is not output. | B |
A
B
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT